Owner's manual

Masterbuilt Manufacturing, Inc.

1 Masterbuilt Court

Columbus, Georgia 31907

Customer Service 1-800-489-1581

BE A PART OF OUR “DADGUM GOOD” COMMUNITY ONLINE:

www.masterbuilt.com | www.dadgumthatsgood.com | www.facebook.com/masterbuilt

Twitter @Masterbuilt @JohnMcLemore @Dadgum atsGood

Control Panel Replacement Instruction for

Generation II Electric Smokers

PARTS AND HARDWARE

Part No.

Qty.

Description

1 1 Control Panel

Required Tool: Short Phillips Head Screwdriver

Part No. 9007120007 and 9007120015

•

ALWAYS REMOVE PLUG FROM OUTLET BEFORE SERVICING!

•

MAKE SURE UNIT HAS FULLY COOLED TO AVOID BURNING!

•

EDGES MAY BE SHARP. USE CAUTION TO AVOID INJURY!

CAUTION

021513-23JH

Check out

our assembly video

on the Masterbuilt

Youtube Channel!

9807140021 032114-23GH

PAGE 1
ut o ck o ly vide e h b C ilt sem sterbu l! s a a our the M hanne on ube C t You Control Panel Replacement Instruction for Generation II Electric Smokers Part No. 9007120007 and 9007120015 BE A PART OF OUR “DADGUM GOOD” COMMUNITY ONLINE: www.masterbuilt.com | www.dadgumthatsgood.com | www.facebook.com/masterbuilt Twitter @Masterbuilt @JohnMcLemore @DadgumThatsGood Required Tool: Short Phillips Head Screwdriver 9807140021 032114-23GH PARTS AND HARDWARE Part No. Qty.
PAGE 2
Disconnect unit from power source, and allow it to fully cool, before replacing control panel. Step 1: Remove screw on left side of smoker body as shown below. Step 2: Remove screw on right side of smoker body. Step 5: Disconnect wires connecting control panel housing to smoker body. Step 6: Remove screws as shown below to remove control panel from housing. Note : Do not disconnect red and black wiring. Step 7: Insert new control panel into control panel housing.