User manual

Masterclock RC 500 User Manual – v2014.01.01
14
Standalone Menu Display Properties
The RC500 can be customized to display time in a variety of
formats and brightness levels.
To enter the configuration menu press and hold [CLOCK] for
approximately 2 seconds.
Press [DOWN] to cycle through the configuration menu.
Press [HOUR], [MINUTE] and [SECOND] to change settings.
Press [CLOCK] to exit the configuration menu.
Each menu setting will be saved until a user makes a change
to the setting or the unit is reset to factory default.
Factory default settings are:
Brightness:
4
Speaker:
On
Time Display Format:
24 hour
Time Zone Offset:
0
Daylight Saving Time:
Off
Time Displayed:
Local
Leading Zero:
Off
Default Settings
::
::
::
::
::
::
::
Brightness
This setting controls the brightness of the LED display and
illuminated buttons.
There are four levels of brightness.
Brightest:
4
Bright:
3
Dim:
2
Dimmest:
1
::
________________
________________
________________
Speaker
When enabled, the unit will emit a short audible tone (3.7kHz)
during initialization and at the end of each timer count.
When speaker is set to off, the unit will continue to
emit a short audible tone during initialization.
::
________: