Owner`s manual

7
ASSEMBLy INSTRUCTIONS
Before assembling the Bar Blender, make sure the Cord is un-1.
plugged.
With the control Panel facing you, place the Blender Base on a dry, 2.
level surface.
Turn the Blender Jar upside down, and place it at on a sturdy 3.
surface.
Position the Rubber Gasket on Blade Assembly so Rubber Gasket 4.
ts securely. Note: Blades are Sharp… handle carefully.
Turn the Blade Cutting Assembly upside down and place the blade 5.
end in the Blender Jar opening.

Turn the Blade Cutting Assembly clockwise until tightened. Once 6.
assembled, turn the Blender Jar right-side up.
Push the Lid on to the top of the Blender Jar. Lid Ring Pull Tab 7.
will be positioned over the Bar Blender handle. See page 8, Figure 1.
Insert the Measuring Cup into the Lid and either turn clockwise or 8.
counter-clockwise to lock in place. See page 8, Figure 2.
Place the Blender Jar on the motor base so that the jar markings 9.
are facing you and the handle is positioned to the right side of the
Control Panel. See page 8, Figure 3.
Plug the Cord into a 120 Volt AC outlet.10.
The Bar Blender is now ready for use.11.
CAUTION: DO NOT ATTEMPT TO OPERATE WITHOUT BLADE

