Owner`s manual
9
To start blending, press and release the desired function button. A 6.
corresponding red indicator light will illuminate while the Bar Blender
is in operation. The red indicator light will go out when the program
has nished. To choose a different program, simply press a different
program button. Note: Depending on the selected program, your
Bar Blender may operate at different speeds or stop and start
during use.
You can also stop blending by pressing the OFF button. In this case, 7.
all blending power will be turned off and blending cannot begin again
until you activate the unit by pressing a program button
PULSE mode allows you to create a quick burst of power for fast, 8.
efcient blending. For pulse blending, turn the Bar Blender off by
pressing the STOP button and then press the PULSE button. The
red light above PULSE will illuminate . Blending will continue at that
speed until you release the button. Repeat as desired in PULSE. To
exit pulse mode, simply release the PULSE button again and press
the STOP button to turn the Bar Blender off.
CRUSHING ICE. Add 1 cup of ice cubes, about 9, to the Blending 9.
Jar. Place the Lid on Blending Jar then repeatedly press and release
the Ice Crush button until the cubes are reduced.
When you are nished blending, turn the Bar Blender off by pressing 10.
the STOP button twice. Remove the plug from the electrical outlet,
and lift the Blender Jar off the Blender Base. Lift straight up, using
a gentle rocking motion if necessary. Do not use a twisting motion.
NEVER REMOVE THE BLENDER JAR WHILE THE MOTOR IS ON.
To dislodge food, use a rubber or plastic spatula to loosen food 11.
lodged around the blade assembly. DO NOT INSERT SPATULA UNTIL
BAR BLENDER IS TURNED OFF AND UNPLUGGED. Be sure
spatula is not in jar when you resume blending.
CLEANINg yOUR PRO POWER
BAR BLENDER
Always unplug your Bar Blender from electrical outlet before cleaning
any part of it.
Remove Blender Jar from Blender Base.1.
Remove Blade Assembly from bottom of Blender Jar. 2.