Use and Care Guide

Circle the model of your cooler and
record the serial number below.
Read Carefully All Of This Manual
Before Installing The Unit
Encierrre con un circulo el modelo de su
enfriador y escribe el número de série abajo.
Lea Con Cuidado Todo Este Manual Antes De
Instalar La Unidad
Serial #
Número De Série
Safety Rules
1. Read instructions carefully.
2. Electrical hook up should be done by a qualifi ed electrician, so
that all electrical wiring will conform to your local standards.
3. Always turn OFF POWER and UNPLUG motor and pump inside
the cooler before installing or performing any maintenance.
4. Your cooler will run on either 120V or 240V A.C., single phase,
60 Hz (cycle) current.
5. Motor and pump have a grounded, molded plug and an automatic
thermal overload switch which will shut motor off when it
overheats. The motor will restart automatically when it cools
down.
WARNING: To reduce the risk of fi re or electric shock, do
not use this fan with any “solid-state fan speed control device.”
Read And Save These Instructions
Vea el Español en el interior.
110498-2 10-13
www.championcooler.com
Table Of Contents
Safety Instructions .......................................................................1
Operation ......................................................................................2
Installation Instructions ............................................................ 2-3
Maintenance Section ....................................................................4
Electrical Wiring Diagram ...........................................................4
Troubleshooting ...........................................................................5
Warranty .......................................................................................5
Parts List (51 & 71 Series Down Discharge) ........................... 6-7
Parts List (51 & 71 Series Side Discharge)..............................8-9
Parts List (51 & 71 Series Up Discharge) ............................ 10-11
Specifi cation Tables (Tablas de Especifi caciones) .....................12
Instrucciones en Español ..................................................... 12-16
Evaporative Cooling
Evaporative cooling is nature’s way of cooling. When air is moved
over a wet surface, water is evaporated and heat is absorbed. When
stepping out of swimming pool with the wind blowing, evaporative
cooling makes you feel cool, even though the air may be warm.
This unit works on the same principle. Air is drawn across wet
fi lter pads where the air is cooled by evaporation and then circulated
throughout the building. It is this combination of cooled air and the
movement of air over the skin which makes it feel cool.
Unlike refrigeration systems which recirculate the air, an evaporative
cooler continually brings in fresh air while exhausting old air. You
are completely replacing the air every 2 to 4 minutes by opening
windows or doors or a combination of both. The air is always fresh,
not stale, laden with smoke and odors as happens with refrigerated
air conditioning.
Models
ADA51 ADA5112
ASA51 ASA5112
AUA51 AUA5112
ADA71 ADA7112
ASA71 ASA7112
AUA71 AUA7112