Use and Care Manual

ManualsBrandsMasterCool ManualsHeating, Ventilation, and Air ConditioningMasterCool 1600 CFM 2-Speed Portable Evaporative Cooler for 800 sq. ft. (with Motor)

INSTALLATION AND OPERATION MANUAL

MOBILE EVAPORATIVE COOLER

Circle the model of your cooler and record the serial number.

Encierrre con un circulo el modelo de su enfriador y escribe

el número de série.

MMBT12 MMBT14

DATE OF PURCHASE:

FECHA DE COMPRA: ___________________

SERIAL NUMBER:

NÚMERO DE SÉRIE: _________________

Read carefully all of this manual before installing the unit /

Lea con cuidado todo este manual antes de instalar la unidad.

TABLE OF CONTENTS

SAFETY INSTRUCTIONS ...................................................... 1

HOW EVAPORATIVE COOLING WORKS ............................. 1

COOLER ASSEMBLY ............................................................. 2

OPERATION ........................................................................... 2

MAINTENANCE ...................................................................... 3

ROUTINE. ......................................................................... 3

YEARLY ............................................................................. 3

TROUBLE SHOOTING ........................................................... 4

SPECIFICATIONS .................................................................. 4

LIMITED WARRANTY ............................................................ 5

INSTRUCCIONES EN ESPAÑOL ................................ 6-9

ILLUSTRATED PARTS LIST /

LISTA ILUSTRADA DE PIEZAS DE REPUESTO

(ENGLISH / ESPAÑOL) .................................................. 10-11

GARANTIA LIMITADA .......................................................... 12

READ AND SAVE THESE INSTRUCTIONS

1. Read these instructions carefully.

2. Unit must be in the Off Position and Unplugged from power

receptacle when installing or performing any maintenance.

3. This cooler will run on 120 volt A.C., 60 Hz (cycle) current

only.

4. Motor and pump are grounded and have an automatic ther-

mal overload switch which will shut motor off if it overheats.

The motor will restart automatically when it cools down.

5. Pump receptacle is for grounded evaporative cooler pump

only. Do not plug anything else into receptacle.

6. Do Not operate any fan with a damaged cord or plug. Dis-

card fan or return to an authorized service facility for exam-

ination and/or repair.

. Do Not run cord under carpeting. Do Not cover cord with throw

rugs, runners or similar coverings. Do Not route cord under

furniture or appliances. Arrange cord away from trafﬁ c area

and where it will not be tripped ove

8. Use only in GFCI protected receptacles.

WARNING: To reduce the risk of ﬁ re or electric shock,

do not use this fan with any “solid-state fan speed control

device.

HOW EVAPORATIVE COOLING WORKS

Evaporative cooling is nature’s way of cooling. When air is

moved over a wet surface, water is evaporated and heat is

absorbed. When stepping out of a swimming pool with the wind

blowing, evaporative cooling makes you feel cool, even though

the air may be warm. The human body itself is cooled primarily

by the evaporation of perspiration.

This unit works on the same principle. Air is drawn across

wet ﬁ lter pads where the air is cooled by evaporation and then

circulated throughout the building. It is this combination of

cooled air and the movement of air over the skin which makes it

feel cool.

Unlike refrigeration systems which recirculate the air, an

evaporative cooler continually brings in fresh air while

exhausting old air. You are completely replacing the air every 2

to 4 minutes by opening windows or doors or a combination of

both. The air is always fresh, not stale, laden with smoke and

odors as happens with refrigerated air conditioning.

WATER

LINE

GRILLE

)

2 SPEED MOTOR

WATER DISTRIBUTION HOSE

FLOAT

WATER PUMP

WATER-SATURATED

COOLER PADS

3 SIDES

AIR FLOW

BLOWER

PN 110522-3 REV. 11-15

Summary of content (12 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL MOBILE EVAPORATIVE COOLER Circle the model of your cooler and record the serial number. Encierrre con un circulo el modelo de su enfriador y escribe el número de série. MMBT12 MMBT14 DATE OF PURCHASE: FECHA DE COMPRA: ___________________ SERIAL NUMBER: NÚMERO DE SÉRIE: _________________ Read carefully all of this manual before installing the unit / Lea con cuidado todo este manual antes de instalar la unidad. TABLE OF CONTENTS SAFETY INSTRUCTIONS ......................
PAGE 2
COOLER ASSEMBLY 1 REMOVE 2 SCREWS AT NOTE: Installation kit and manual are inside the unit. 1. Unpack unit from carton. Please recycle and discard of packing material responsibly. 2. Two screws secure each louver panel. Locate and remove the screws about 1-1/2 inches below the plastic work top. Replace these screws when re-installing panel. 3. Access the interior of the unit by using the handhold at the bottom of the louvered side to lift up and out of the cabinet.
PAGE 3
MAINTENANCE WARNING: Before doing any maintenance be sure power is off and unit is unplugged. This is for your safety. ROUTINE MAINTENANCE WEEKLY: 1. Drain and replenish water from the cooler at least weekly. This keeps the water in the pan fresh and helps prevent scale and mineral deposit accumulation on the pads. AT THE END OF THE SEASON OR DURING EXTENDED PERIODS OF NON-USE: 1. 2. 3. Completely drain the reservoir and disconnect water supply. Ensure no water remains during freezing weather.
PAGE 4
TROUBLESHOOTING Problem Possible Cause Remedy Failure to start or no air delivery 1. No electrical power to unit • Fuse blown • Circuit breaker tripped • Electric cord unplugged or damaged 2. Belt too loose or tight 3. Motor overheated • Belt too tight • Blower bearings dry 4. Motor locked 1. Check power • Replace fuse • Reset breaker • Plug in cords or replace if damaged 2. Adjust belt tension 3. Determine cause of overheating • Adjust belt tension • Oil blower bearings 4.
PAGE 5
MASTERCOOL MOBILE EVAPORATIVE COOLER ONE YEAR LIMITED WARRANTY POLICY SALES RECEIPT REQUIRED AS PROOF OF PURCHASE FOR ALL WARRANTY CLAIMS. This warranty is extended only to the original purchaser of this evaporative cooler when the unit is installed and used under normal conditions against defects in workmanship and materials as follows:  One (1) year from date of sale on the unit The manufacturer will replace the defective part/product, at its discretion, with return freight paid by the manufacturer.
PAGE 6
MANUAL DE INSTALACIÓN Y OPERACIÓN MÓVIL ENFRIADOR EVAPORATIVO Encierrre con un circulo el modelo de su enfriador y escribe el número de série. MMBT12 REGLAS DE SEGURIDAD 1. Lea las instrucciones con cuidado. 2. La unidad debe estar Apagada y Desconectada de la electricidad cuando se instale o haga cualquier mantenimiento. 3. Su enfriador funciona sólo con corriente alterna de 120 voltios, 60 Hz. (ciclos).
PAGE 7
CONJUNTO DEL ENFRIADOR NOTA: Las ruedas y el manual se encuentran dentro de la unidad. 1. Desembale la unidad de la caja. Por favor, reciclar y desechar el material de embalaje de manera responsable. 2. Dos tornillos fijan cada panel. Localice y retire los tornillos que se encuentran unas 1-1/2 pulgadas por debajo de la superficie de plástico. Vuelva a colocar los tornillos al volver a instalar el panel. 3.
PAGE 8
MANTENIMIENTO ADVERTENCIA: Antes de hacer cualquier mantenimiento, compruebe que la unidad esté apagada y desconectada de la electricidad. Esto es por su seguridad. MANTENIMIENTO GENERAL SEMANALMENTE: • Drenar y reponer el agua del enfriador al menos semanalmente. Esto mantiene el agua dulce en la bandeja y ayuda a prevenir la acumulación de la escala y depósitos minerales en los filtros.
PAGE 9
LA LOCALIZACIÓN DE AVERÍAS Problema Causa Posible Remedio No arranca o no sale aire 1. No llega corriente • Fusible fundido • Cortacircuito desactivado • Cable eléctrico dañado 2. Correa muy floja o apretada 3. Motor recalentado • Correa muy apretada • Cojinetes de la rueda están secos 4. Motor parado 1. Revise la corriente • Cambie el fusible • Restablecer el cortacircuito • Reemplace el cable 2. Ajuste la tensión de la correa 3.
PAGE 10
MMBT12 Parts Diagram 9 8 3 7 11 10 15 24 25 2 33 34 27 4 47 41 43 42 6 32 36 16 46 45 5 37 7 1 8 9 35 50 48 39 11 38 39 40 38 51 MMBT14 Parts Diagram 30 18 28 49 13 14 10 3 8 12 15 9 10 11 2 34 28 26 27 24 33 23 20 30 31 32 16 7 43 17 18 22 21 19 1 47 5 38 38 39 37 41 42 46 49 50 39 11 10 48 6 35 9 44 45 4 7 8 13 14 12 40 51 36 10 110522-3
PAGE 11
PARTS IDENTIFICATION/ IDENTIFICACIÓN DE PIEZAS When ordering parts, please be sure to furnish the following information on all orders. Failure to do so may delay your order. / Al pedir piezas, incluya toda la información siguiente con su pedido. El no proporcionar toda esta información resultará en una demora. 1. Model number / El Modelo, 2. Descripton and part number / Descripción y número de pieza 3. Serial number / Número de serie 4.
PAGE 12
MASTERCOOL ENFRIADOR MÓVIL POLÍTICA DE GARANTÍA LIMITADA UN AÑO PARA CUALQUIER RECLAMO RELACIONADO CON LA GARANTÍA ES NECESARIO PRESENTAR EL RECIBO COMO PRUEBA DE COMPRA.