User's Manual

2
1
Fig. 3
11
Keep Work Areas Clean
ASSEMBLING THE BLADE RAISING/
TILTING CONTROL HANDLE (FIG. 2)
RIP FENCE (FIG. 3)
WARNING: KEEP THE WORK AREA CLEAN, UNCLUTTERED, AND WELL-LIT. DO NOT
WORK ON A FLOOR SURFACE THAT IS SLIPPERY FROM ACCUMULATED SAWDUST,
DEBRIS OR WAX.
WARNING: IN ORDER TO AVOID INJURY FROM AN ACCIDENTAL START-UP, VERIFY
THAT THE POWER SWITCH IS IN THE “OFF” POSITION, THAT THE SAFETY KEY IS
REMOVED, AND THAT THE POWER CORD IS NOT PLUGGED INTO THE OUTLET. IN
ORDER TO AVOID SERIOUS INJURY, THE REAR OF THE TABLE INSERT MUST BE
FLUSH WITH THE TABLE DURING ALL SAWING OPERATIONS. A RUBBER ADJUSTING
SPACER IS PROVIDED UNDER THE REAR OF THE INSERT FOR THIS PURPOSE.
Accumulated sawdust and wood chips can pose a safety hazard.
each cutting operation.
fence in position.
Fig. 2
1
2
CAUTION
LASER RADIATION.
Do not stare into the beam or view it directly using optical instruments.
Maximum output: <5 mW Wavelength: 630-665 nm Protection Class: IIIA