Specifications

SAFETY CHECKS
The following checks and services are essential to safe
boating and must be performed. Get in the habit of
performing these checks in the same order each outing so
that it becomes routine.
DO NOT launch or operate the boat if any problem
is found during the Safety Check. A problem could
lead to an accident during the outing, resulting in
serious injury or death. Any and all problems
should receive attention immediately. See your
MasterCraft dealer for assistance.
BEFORE EACH OPERATION
These tasks are best accomplished before the boat is
launched.
Check the weather report, wind and water conditions.
Check for recommended on-board tools and parts.
Check that all drain plugs are installed properly, includ-
ing bilge and rear drain.
Check the propeller and shaft for damage.
Check the cooling water intake pick-up and transmission
cooler for blockage.
(Additional details on this will follow in the Scheduled
Maintenance Checks and Service Section.)
Check the raw water impeller if the boat showed signs
of over-heating during the last usage.
AND SERVICES
Check the engine oil level.
Check that there is an adequate supply of fuel.
Check that the steering system operated properly.
Check that required safety equipment is on-board.
Check that the mandatory personal flotation device
for each passenger is on-board.
Check that fire extinguisher is fully charged.
Check that no fuel, oil or water is leaking or has
leaked into the bilge component.
Check all hoses and connections for leakage or
damage.
Check that the alternator belt is in good condition.
Check the engine drain plugs.
Check that all required Scheduled Maintenance
Checks and Services
(see following sections) were performed.
DURING OPERATION
Check gauges frequently for operating conditions.
Check that controls operate smoothly.
Check for excessive vibration.
AFTER OPERATION
Check for fluid leaks.
Check the fins, propeller, rudder and shaft for
damage after removing the boat from the water.
In boats equipped with a ballast system, drain water
from the ballast before towing.
2006 MasterCraft Owners Manual–Page 7-1