Specifications

UNDERWAY
If the oil pressure gauge indi-
cates low or no oil presssure, stop
and check the oil level. If the tem-
perature gauge indicates overheat-
ing, stop and check the raw water
impeller for blockage. DO NOT
operate the boat until the cause
for the warning has been found
and corrected.
Continued operation after the
warning light has illuminated may
cause severe engine damage. This
will
void your warranty.
STOPPING
Step 1: Slowly bring the control
lever to the neutral position. If
the boat has been driven for a
long period of time or at high
speed, allow the engine a 2-3
minute cool-down period at low
idle (600-800 RPM).
Step 2: Turn the ignition key to
the OFF position to stop the en-
gine.
Step 3: If any problems were en-
countered during operation, have
the boat inspected by your
MasterCraft dealer. Request any
necessary repairs before operat-
ing again.
Note:
When shifting from
forward to reverse or reverse
to forward,
be sure
to stop
the control
lever in the neutral position
and
ALLOW THE EN-
GINE to fall between 600-
800 RPM before
completing the shift.