Specifications

2005 MASTERCRAFT OWNERS MANUAL–PAGE 15-2
• Inspect the propeller shaft log for exces-
sive water entry.
• Inspect the fuel system lines and con-
nections for leakage.
• Inspect the exhaust system for leaks.
As you start the engine:
• Check that the voltage registers a fully
charged battery.
After running the engine at least five
minutes:
• Check the transmission fluid level.
• Check the engine oil level.
QUARTERLY (EVERY 50 HOURS)
Note: MasterCraft recommends that
these functions be performed by factory-
trained MasterCraft technicians.
Before the engine has been started or after
it has cooled:
• Lubricate the engine starter gear and
shaft.
• Check the safety equipment.
After the engine has run at least three
minutes:
• Change the engine oil and filter.
ANNUALLY (EVERY 100 HOURS)
Note: MasterCraft recommends that these
functions be performed by factory-trained
MasterCraft technicians.
Before the engine has been started or after
it has cooled:
• Clean the engine flame arrestor.
• Replace the fuel filter (trained tech-
nician-only function due to pressure
in-line).
• Perform an engine tune-up.
• Replace the raw water impeller.
• Replace the ballast pump impeller.
• Check the propeller shaft coupler alignment.
• Lubricate the steering system.
• Lubricate the throttle and shift cables.
• Check the engine mounts.
• Inspect the complete fuel system for leakage.
After the engine has run at least five minutes:
• Change the engine oil and filter.
• Change the transmisison fluid.
Details follow in the next few sections.
MasterCraft recommends that
MANY of these functions be
performed by factory-
trained
MasterCraft TECH-
NICIANS.