Owner`s manual

Cleaning
One of the best ways to keep the material looking fresh and new, and to delay the need for deep or vigor-
ous cleaning, is to hose off fabrics with clear water on at least a monthly basis with clean water. is practice
will help prevent dirt from becoming deeply embedded in the fabric, and it will eliminate the need for more
frequent and more vigorous cleanings.
In most environments, a thorough cleaning will be needed approximately every two (2) years.
e fabric can be cleaned while still in the boat. When cleaning, it is important to observe the following:
• Always use a natural soap—never detergent.
• Water should be cold to lukewarm, but never more than 100 degrees.
• Air dry only. Never apply heat to the fabric.
Begin by brushing off loose dirt, and then hose down the material. Prepare a cleaning mixture of water
and a mild, natural soap that is free of detergents. Use a soft-bristle brush to clean, allowing the soap to soak
in. Rinse thoroughly and allow the fabric to thoroughly air dry.
If stubborn stains persist, you can use a diluted chlorine bleach/soap mixture for spot cleaning of mildew,
roof run-off and other similar stains. Please keep in mind that chlorine bleach will not change the color of the
fabric, but chlorine bleach will eventually break down the fiber of any fabric. erefore, this cleaning method
should be used as infrequently as possible.
e cleaning mixture should be mixed as follows:
• Four ounces (one-half cup) of chlorine bleach.
• Two ounces (one-fourth cup) of natural soap.
• One gallon of water.
Clean with a soft-bristle brush and allow the mixture to soak no longer than twenty (20) minutes. Rinse
thoroughly and allow to completely air dry. Repeat if necessary.
If the top or boat cover is suitable in size for a washing machine, these steps should be followed:
• Use only natural soaps—no detergent.
• Wash and rinse in cold water.
• Air dry. (Never put the fabric in a dryer.)
As part of the finishing process, the material has been treated with a fluorocarbon finish, which enhances
water repellency. is finish is designed to last for several years, but it must be replenished after a thorough
cleaning. Based on test results, the manufacturer recommends 303 High Tech Fabric Guard™ as the preferred
re-treatment product.
After cleaning and air drying, apply 303 in a thin, even coat. When it has dried, apply a second thin, even
coat. ese two (2) light coatings are more effective in restoring fabric water resistance than a single heavy
coating. Keep in mind that 303 High Tech Fabric Guard™ will work only as well as it is applied. is means that
the fabric must be free of dirt and detergents or the Fabric Guard will wash away with the dirt particles.
Fabrics should be retreated after thorough cleaning or after five (5) years of use.
Enclosed Head
An option on some models is the enclosed, portable head. is
convenience should be emptied on-shore within an acceptable
holding tank, septic system or sewer. It should never be emptied
within the boating body of water or on-shore, except in an ap-
proved receptacle!
e head should be cleaned after each outing. After thoroughly
cleaning with a mild detergent, add a neutralizing chemical made
especially for portable heads, such as that found in RV centers.
e neutralizing chemical will help deal with potential odors that
might otherwise be foul.
Slick Boot
e optional Slick Boot should periodically be dismantled,
cleaned and the wand thoroughly rinsed. e Slick Boot material
can sometimes become gelled, particularly in colder weather.
Acceptable Upholstery Cleaners
MasterCraft Vinyl Dressing
Vinyl Finish Vinyl Cleaner
Dish Soap (such as Dawn or Ivory)
303 High Tech Fabric Guard™
2011 Owners Manual...Cleaning the Boat...Page 14-4