Operator`s manual

Page 36
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
8. Saw does not start.
1. Power cord is not plugged in. 1. Plug in Power cord.
2. In-house circuit fuse is blown. 2. Replace the fuse.
3. In-house circuit breaker is
tripped.
3. Reset the circuit breaker.
4. In-house circuit switch is
damaged.
4. Have the cord or switch
replaced by a qualied
service technician.
5. Inner overload protection
works.
5. Refer to “OVERLOAD
PROTECTION”.
9. Blade makes poor
cuts.
1. Blade is dull or dirty.
1. Clean, sharpen or replace
the blade.
2. Blade is the wrong type for
cut being made.
2. Replace with the proper
type.
3. Blade is mounted backwards. 3. Remount the blade.
10. Saw does not make
accurate 90° or 45°
cuts.
1. Positive stops inside the
cabinet need adjusting (Bevel
cuts).
1. Adjust the positive stops.
2. Miter gauge is misaligned
(Miter cuts).
2. Adjust the miter gauge.
11. Blade does not
lower when turning
the Height/
bevel-adjusting hand
wheel.
1. Locking lever is not at full left
position.
1. Move the locking lever to
the left.