Use And Care Manual

TOOL OPERATION CHECK
A. Pull secondary trigger and not to pull primary trigger.
THE TOOL MUST NOT CYCLE.
B. Pull secondary trigger and pull primary trigger.
THE TOOL MUST CYCLE.
Keep the tool away from yourself and others when connecting air
source.
Remove all fasteners from tool before performing tool operation
check.To reduce the risk of injury to yourself and others, check the
tool before beginning work each day or if the tool is dropped, receive
a sharp blow, been run over, etc. If the tool does not work as it should,
contact Menards service center immediately.
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANUAL
OBSERVE THE FOLLOWING FOR SAFE OPERATION
• .dengised saw ti hcihw rof esoprup eht rof ylno loot citamuenp ecrofretsaM eht esU
• Never use this tool in a manner that could cause a fastener to be directed
toward the
user or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact trip in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
•
Do not
•
continue to use a tool that leaks air or does not function properly.
Notify Menards
service center if your tool continues to experience functional problems.
Page 9