Product Manual

Page 15
PROBLEM POSSIBLE CAUSE SOLUTION
The machine does
not start
when you push the
trigger.
No electrical contact
between the machine
and the battery pack.
1. Remove battery pack.
2. Check contact and install the battery pack
again.
The battery pack is
depleted.
Charge the battery pack.
The lock-out button
and trigger are not
pushed at the same
time.
1. Push the lock-out button and hold it.
2. Pull the trigger to start the machine.
The machine stops
when you cut.
The guard is not
attached to the
machine.
Remove the battery pack and attach the guard
to the machine.
Heavy cutting line is
used.
Use only with the nylon cutting line of 0.095" /
0.080" (2.4 mm / 2.0 mm) diameter.
The grass winds
around the motor
shaft or the trimmer
head.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and
trimmer
head.
The motor is
overloaded.
1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as
the load is removed.
3. When you cut, move the trimmer head in and
out of the grass to be cut and remove no more
than 8" in pass.
The battery pack or
machine is too hot.
1. Cool the battery pack until its function returns
to normal.
2. Cool the machine for approximately 10
minutes.
The battery pack is
disconnected from
the tool.
Install the battery pack again.
The battery pack is
depleted.
Charge the battery pack.
The line does not
advance.
Not enough line on
spool.
Install more line.
Lines are worn too
short.
Advance the cutting line.
Lines are tangled on
spool.
1. Remove the lines from the spool.
2. Wind the lines.
TROUBLESHOOTING