Owner`s manual

15
SAWDUST EJECTION PORT
This miter saw comes with a dust
bag to help you keep the work area
clean. The dust bag is ideal for
smaller jobs.
Use a 2 1/2-in. vacuum hose adapter
to hook up your saw to a wet/dry
vacuum (sold separately).
To install dust bag squeeze the
metal collar wings located at the
opening of the dust bag. Place the
dust bag neck opening around the
sawdust ejection port (located on
saw arm, behind upper blade guard)
(Fig. 3) and then release the metal
collar wings. (Fig.3a).
ADJUSTMENTS
SQUARING THE BLADE TO THE FENCE (Fig. 4)
WARNING: Failure to unplug your saw could result in accidental starting
causing serious injury.
1. Set the bevel and miter angles to
0° degrees.
2. Lower and lock the saw arm into
the “DOWN” position.
3. Using a square lay the heel of
the square against the blade,
and the rule of the square
against the fence.
NOTE: Be sure to rest the square
against the body of the blade and
not against the teeth of the blade.
Fig. 3
Dust Ejection
Port
Dust Bag
Fig. 3a
Fig. 4