Owner`s manual

SQUARING THE BLADE TO THE MITER TABLE (Fig. 6, Fig.6b)

WARNING: Failure to unplug your saw could result in accidental starting

causing serious injury.

1. Set the bevel and miter angle

scales to 0°and lock in place.

2. Lower and lock the saw arm into

the “DOWN” position.

3. Place a combination square

on the miter table with the rule

against the table and heel of the

square against the saw blade.

NOTE: Be sure to rest the square

against the body of the blade and

not against the teeth of the blade.

4. Loosen the clamped screw by

hex key as Fig.6 shown.

5. Loosen the bevel lock knob;

loosen the bolts by the hex

wrench as Fig.6b shown. Screw

the adjustment bolt in or out

far enough until the leg of the

protractor is ﬂush with the saw

blade over its entire length.

6. Once the angle is set, tighten

all the bolts and the bevel lock

knob.

Fig. 6

Fig. 6a

Fig. 6b

Blade 90° Square to Miter Table