Owner`s manual

20
OPERATION
CAUTION: ALWAYS make sure the arbor lock button is released so the
blade can rotate freely. MAKE SURE that the locking pin is loose and that the
saw head moves freely up and down. ENSURE that all clamps and locks are
tightly in place and that there is no excessive play in any parts.
HOW TO USE THE DUAL LASER LINE (Fig.11)
1. Mark your workpiece with a
pencil line at the point to be cut.
2. Push the Laser ON/OFF switch
“On” to activate the “bright red
laser line”. Align your pencil line
in the middle of the dual “red
laser lines”.
4. Clamp your workpiece in place
with the hold down clamp.
5. Follow all of the cutting
instructions for the type of cut
you want to make starting on “CROSS CUTTING”
APPLICATIONS
The blade included with this saw is ideal for a wide variety of wood cutting
operations. Use your compound miter saw for the purposes listed below:
• Crosscutting wood and wood base materials.
• Crosscutting plastics, like PVC, CPVC, ABX, solid surfacing materials and
other plastics.
• Crosscutting miter joints for picture frames, moldings, door casings, chair
rail, shoe and baseboards.
• Compound cuts for decorative wood molding, such as chair rail, cove
molding and picture frames and other fine joinery.
This tool is NOT recommended for cutting ferrous metals, such as iron, steel,
stainless steel, or alloys of these metals. Cut non-ferrous metals ONLY if you
are under the supervision of an experienced person. Also DO NOT cut stone,
brick, or concrete with this miter saw.
WARNING: BEFORE starting any cutting operation, clamp or bolt your
compound miter saw to a work bench or flat stable work surface. NEVER
operate your miter saw on the floor or in a crouched position. Failure to heed
this warning could result in serious personal injury.
Fig. 11