Owner`s manual

22
1. Release the tightening knob
counterclockwise, and separate
the two parts. (Fig.12a, Fig12b).
2. Insert the hold down clamp
in the hole as shown, press
the lock button to adjust the
the width according to the
workpiece. (Fig.12c)
3. Tighten the hold down clamp
knob clockwise.
NOTE: When you do the bevel
45°cutting, You must pull to extend
the fence by releasing the fence
locking knob to prevent from
scratching with the saw arm.
CLAMPING WIDE WORKPIECES
When cutting wide workpieces
(such as 2-in. x 8-in. boards) the
boards MUST BE clamped with
the hold down clamp provided or a
C-clamp (sold separately).
CAUTION: Pay attention to the
position of your body and hands.
Proper positioning of your body
and hands when operating the mi-
ter saw will make cutting easier
and safer. NEVER place hands near
the cutting area.
Fig. 12a
Fig. 12b
Fig. 12c