Owner`s manual

USING THE MITER SAW

CAUTION: Always hold the cutting handle ﬁrmly when making a cut, be-

cause the starting and stopping action of the motor may cause the handle to

move up or down slightly.

NOTE: Make the ON/OFF trigger

switch childproof. Insert a small

padlock or chain with padlock

through the holes in the ON/OFF

trigger switch, locking the switch

and preventing children or other

unauthorized users from turning

on the saw (Fig. 13).

CROSSCUTTING (Fig. 13a and 14)

A crosscut is a cut made across

the grain of the workpiece. A

straight crosscut is a cut made

with the miter table set in the 0°

position (Fig.13a). Miter crosscuts

are made with the miter table set

at some angle, left or right, other

than 0° (Fig.14).

Fig. 13

Fig. 13a

0° Straight Crosscut

45° Miter Crosscut

Fig. 14