Owner`s manual

11. When cutting long workpieces,

pull out extension wing for

extra support for the long

workpieces. (Fig. 14b)

CAUTION: NEVER use another person as an additional support for a work-

piece that is longer or wider than the basic saw table, or to help feed, sup-

port, or pull the workpiece.

WARNING: To avoid serious personal injury, ALWAYS keep your hands

outside the “no hands zone”, as marked on the saw table, which is at least 3

inches from the blade. Also, NEVER perform any cutting operation “freehand”

(i.e. without holding the workpiece against the fence); the blade could grab

the workpiece, causing it to slip and twist.

12. BEFORE turning on the saw, perform a dry run of the cutting operation by

lowering the saw arm to make sure that no problems will occur when the

cut is made.

13. Hold the saw handle and use your middle ﬁnger to turn on the laser

switch by pushing it forward.

14. To turn on saw, push the safety lock button in with your thumb while

squeezing the On/Off trigger switch located under the handle (Fig.1a).

Allow several seconds for the blade to reach maximum speed.

15. Slowly lower the blade into and through the workpiece.

16. Release the safety lock and trigger switch and turn off the laser switch.

Allow the saw blade to stop rotating BEFORE raising the blade out of the

workpiece.

NOTE: You can turn on the light LED switch for lighting in the dark areas.

Fig. 14b