Owner`s manual

30
WARNING: To avoid serious personal injury, ALWAYS keep your hands
outside the “no hands zone”, as marked on the saw table, which is at least 3
inches from the blade. Also, NEVER perform any cutting operation “freehand”
(i.e. without holding the workpiece against the fence); the blade could grab
the workpiece, causing it to slip and twist.
14. Make sure that there will be no obstructions to interfere with when
making the cut.
15. Hold the saw handle and use your middle finger to turn on the laser
switch by pushing it forward
16. To turn on saw, push the safety lock button in with your thumb while
squeezing seconds for the blade to reach maximum speed.
17. Slowly lower the blade into and through the workpiece.
NOTE: You can turn on the light LED switch for lighting in the dark areas.
18. Release the safety lock and trigger switch, and turn off the laser switch.
Allow the saw blade to stop rotating BEFORE raising the blade out of the
workpiece.
CUTTING COMPOUND MITERS
To help you to make the correct settings, use the compound angle setting
chart below. Since compound cuts are the most difficult to accurately obtain,
plan carefully and make trial cuts in scrap material prior to making your
required cut.