Owner`s manual

38
LOWER BLADE GUARD
WARNING: DO NOT use the saw without the lower blade guard. The low-
er blade guard is attached to the saw for your protection. Should the lower
blade guard become damaged, do not use the saw until the damaged guard
has been replaced. Check the lower blade guard regularly; making certain
that it is in proper working order.
CAUTION: When cleaning the lower blade guard, unplug the saw from the
power source receptacle to avoid unexpected startup.
NOTE: Do not use solvents on the guard, as they may cause any plastic parts
to become “cloudy” or brittle.
SAWDUST
Periodically, sawdust will accumulate under the worktable and base. This
could cause difficulty in the movement of the worktable when setting up a
miter cut. Frequently blow out or vacuum up the sawdust.
WARNING: Always wear safety goggles or safety glasses with side
shields during power tool operations, or when blowing dust. If operation is
dusty, also wear a dust mask.
LUBRICATION
All the motor bearings in this tool are lubricated with a sufficient amount
of high-grade lubricant for the life of the unit, under normal operating
conditions; therefore, no further lubrication is required.
SERVICE OF LASER GUIDE
Use a soft paintbrush or similar device to remove all sawdust and debris.
(Compressed air contains fine oil droplet which adhere to the lens; you
should therefore not blow out the lens with compressed air)