Owner`s manual

 AVOID body contact with grounded surfaces, such as pipes, radiators,

ranges and refrigerators. There is an increased risk of electric shock if

your body is grounded.

 DO NOT expose power tools to rain or wet conditions or use power tools in

wet or damp locations. Water entering a power tool will increase the risk

of electric shock. This tool is intended for indoor use only.

 If operating a power tool in damp locations is unavoidable, ALWAYS USE

a Ground Fault Circuit Interrupter to supply power to your tool. ALWAYS

WEAR electrician’s rubber gloves and footwear in damp conditions.

 INSPECT tool cords for damage. Have damaged tool cords repaired by

qualiﬁed person. BE SURE to stay constantly aware of the cord location

and keep it well away from the moving blade.

 DO NOT abuse the cord. NEVER use the cord to carry the tool by or to

pull the plug from the outlet. Keep cord away from heat, oil, sharp edges

or moving parts. Replace damaged cords immediately. Damaged cords

increase the risk of electric shock.

SAFETY PRECAUTIONS FOR LASERS

This miter saw has a built-in laser light.

The laser is a Class IIla and emits output

power of a maximum 2.5mW and 635-665nm

wavelengths. These lasers do not normally

present an optical hazard. However, DO NOT

stare at the beam as this can cause ﬂash

blindness.

CAUTION: The following label is on your tool. It indicates where the saw

emits the laser light. BE AWARE of the laser light location when using. AL-

WAYS MAKE SURE that any bystanders in the vicinity of use are made aware

of the dangers of looking directly into the laser.

WARNING: LASER LIGHT. LASER RADIATION. Avoid Direct Eye Exposure.

DO NOT stare into beam. Only turn laser beam on when the saw is on the

workpiece.

WARNING: Use of controls, adjustments or performance of procedures

other than those speciﬁed in this manual may result in hazardous radiation

exposure.

CAUTION