0" Contractor Table Saw 240-0037 OPERATOR’S MANUAL CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference. For questions / comments, technical assistance or repair parts Please call toll free at: 1-877-684-8912 (Monday - Friday 8am - 6pm EST.
TABLE OF CONTENTS ENGLISH Description Unpacking Safety Rules Assembly Installation Operation Maintenance Troubleshooting Replacement Parts List Masterforce® Warranty Belt Tension & Replacement Service Record Form 2 2-3 3-4 4-11 11-13 13-20 21 22-23 24 25 26 27 1
240-0037 DESCRIPTION 240-0037 UNPACKING 1(877)684-8912 2
240-0037 SAFETY RULES 297 3
240-0037 ASSEMBLY 4
240-0037 Front panel and Rear panel are the same. Front panel has warning label. Attach one corner of left panel (the panel with stamped hole assembly for the blade guard and push stick storage brackets (See Figure 16)) to front panel with the warning label. Attach the other corner of the left panel to the rear panel (without warning label) Repeat above two steps for attachment of right panel (the panel with stamped hole assembly for the rip fence brackets (See Figure 15)).
240-0037 6
240-0037 plastic Plastic Feet Hardware Required: Four self-taping screw, six M5 flat washer, six M5 hex nut, four M5 x 12 socket head bolts and two hex bolts M5 x 20. flat washers and two hex bolts.
240-0037 8
240-0037 9
240-0037 10
240-0037 11
240-0037 INSTALLATION 12
240-0037 OPERATION 13
240-0037 14
240-0037 15
240-0037 16
240-0037 17
240-0037 18
240-0037 19
240-0037 20
240-0037 MAINTENANCE 21
240-0037 TROUBLESHOOTING 22
0-0037 TROUBLESHOOTING 23
Replacement Parts List 240-0037 For questions / comments, technical assistance or repair parts - Please call toll free at: 1-877-684-8912 (Monday - Friday 8am - 6pm EST.
240-0037 MASTERFORCE® CONTRACTOR SAW WARRANTY 1(877)684-8912 25
SKU: 240-0037 Figure 63. Checking belt tension Loosen the cap screw on the motor shown in Figure 62, and pivot the motor up and down to make sure that it is movable. Figure 62. Motor mounting nut. Press the belt in the center to check belt tension. The belt is correctly tensioned when there is approximately 1/4" deflection when it is pushed with moderate pressure, as shown in Figure 63.
240-0037 27
