240-0037 Fie: 1 ATTACH CORD WRAP HOOKS Safer to Figure 12. Tools Required: dmm Hex Wrench Hardware Required: Two M8 X 16 socket pan head bolts, two M8 fiat washers and two M8 hex nuts (Hardware bag #a}. + insert a bolt into 3 cord wrap hank and place against the hales on the left SIDS of the saw cabinet. « Secure hook in position using flat washer and hex nut. Repeat for other hook. Figure 12 ATTACH BASE TO CABINET Refer to Figures 13 and 14.
2460037 BLADE GUARD AND PUSH STICK STORAGE BRACKETS Refer to Figure 16, Tools Required: Phillips screwdriver and 4mm hex wren Hardware Required: Four M3 x 10 pan head screws, foist M3 Jock, washers, four M3 flat washers, four M5 x 12 socket bead Softy, far M5 lock washers and four M5 flat washers {Hardware bsg #4} * instill the push stick storage brackets to the left side patriarchal base using four screws, lock washers and flat washers.
240-0037 CHECK TABLE ALIGNMENT Refer to Figures 20, 21 and 22. * Saws are shipped from the factory with the table adjusted 20 the miter gauge slots are parallels{ to the saw blade. However, in order to obtain the best results from the saw, it is suggested this adjustment be checked before operating. + A simple method of sacking alignment is as follows: Bolt or clamp & dowel rod or similar object to miter gauge (2 combination square can ba substituted).
