Use And Care Manual

Page 7
ASSEMBLY
UNPACKING
This product requires assembly.
• Carefully remove the product and any
accessories from the box. Make sure that
all items listed in the package contents
section are included.
• Inspect the product carefully to make sure
no breakage or damage occurred during
shipping.
• Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the product.
• If any parts are damaged or missing, please
call 1-844-MSTR4CE (844-678-7423) for
assistance.
WARNING
Do not use this
product if any parts on the packing list are
already assembled to your product when
you unpack it. Parts on this list are not
assembled to the product by the
manufacturer and require customer
installation. Use of a product that may
have been improperly assembled could
result in serious personal injury.
TRIGGER HANDLE
1. Move the trigger handle onto the rear
blower tube.
2. Move the trigger handle to necessary
location on the rear blower tube.
3. Install and tighten the available short screw.
FIG. 2
Rear blower tube
Trigger handle
FIG. 3
Screw
REAR BLOWER TUBE
1. Put the hose clamp around the exible tube.
2. Put the end of the rear blower tube into the
exible tube at a small angle.
3. Push the end of the rear blower tube into the
exible tube.
4. Install and tighten the available long screw
into the hose clamp.
FIG. 4
Front blower tube
Hose clamp
Flexible
tube