Use And Care Manual

Page 8
To remove the battery pack
1. Press and hold the battery release button
with rm grip.
2. Grasp the trigger handle rmly. Pull the
battery pack out of the handle.
Battery
release
button
FIG. 6
ASSEMBLY
FRONT BLOWER TUBE
1. Align the grooves on the front blower tube
with the tabs on the rear blower tube.
2. Install the front blower tube onto the rear
blower tube until the tabs engage the
grooves.
3. Turn the front blower tube in the direction of
the arrow until the tabs lock into position.
FIG. 5
Front blower tube
Rear blower tube
THE BATTERY PACK
WARNING
Follow these instruc-
tions in order to avoid injury and to reduce the
risk of electric shock or re:
• Replace the battery pack or the charger
immediately if the battery case or charger
cord is damaged.
• Verify that the switch is in the OFF position
before inserting or removing the battery
pack.
• Verify that the battery pack is removed
and the switch is in the OFF position
before inspecting, adjusting, or performing
maintenance on any part of the blower.
To install the battery pack
1. Align the tongue of the battery pack with
the cavity in the handle housing.
2. Insert the battery into the battery opening
until the battery release button locks into
place.
3. Push the battery pack into the handle until
both sides lock. The latch button will click
when locked into place.
4. Do not use force when inserting the battery
pack. It should slide into place and click.