Owner`s manual

ON/OFF SWITCH AND LOCK-ON BUTTON (Fig. 9)

To start the drill:

1. To turn the tool “ON”, depress the

trigger switch (1). Increase the

pressure on the trigger switch to

increase the speed.

2. To turn the tool “OFF”, release the

trigger switch (1).

CAUTION! Allow the motor to

come to a complete stop before set-

ting the drill down.

Lock on for continuous operation:

The trigger switch is equipped with a lock-on button.

1. To activate the lock-on feature, squeeze the trigger switch (1) to turn the

tool “ON”, and then depress the lock-on button (2). The trigger switch is

locked “ON”.

2. To disable the lock-on button and turn the tool OFF, squeeze the trigger

switch (1) again. The lock-on button will disengage. Release the trigger

switch to turn the tool “OFF”.

OPERATING INSTRUCTIONS

DRILLING OPERATION

Hold the drill comfortably, with your ﬁnger on the trigger switch.

Use the auxiliary handle whenever possible to gain extra control and to

prevent fatigue.

NOTE:

• Use sharp drill bits only.

• For wood, use twist-drill bits, spade bits, power-auger bits, or hole saws.

• For metal, use high-speed, steel-twist drill bits or hole saws.

• For masonry (brick, cement, cinder block, etc.) use carbide-tipped drill

bits.

• Be sure that the material to be drilled is anchored or clamped ﬁrmly.

• If drilling thin material, use a “back-up” block to prevent damage to the

material.

Fig. 9