Owner`s manual

• Avoid body contact with grounded surfaces such as pipes, radiators,

ranges and refrigerators. There is an increased risk of electric shock if

your body is grounded.

• Don’t expose power tools to rain or wet conditions. Water entering a

power tool will increase the risk of electric shock.

• Do not abuse the cord. Never use the cord to carry the tool or to pull

the plug from an outlet. Keep the cord away from heat, oil, sharp edges

or moving parts. Replace damaged cords immediately. Damaged cords

increase the risk of electric shock.

• When operating a power tool outside, use an outdoor extension cord

marked “W-A” or “W”. These cords are rated for outdoor use and reduce

the risk of electric shock.

Personal Safety

• Stay alert, watch what you are doing and use common sense when

operating a power tool. Do not use the tool while tired or under the

inﬂuence of drugs, alcohol, or medication. A moment of inattention while

operating power tools may result in serious personal injury.

• Dress properly. Do not wear loose clothing or jewelry. Contain long hair.

Keep your hair, clothing, and gloves away from moving parts. Loose

clothes, jewelry, or long hair can be caught in moving parts.

• Avoid accidental starting. Be sure that the switch is off before plugging in

the tool. Carrying tools with your ﬁnger on the switch or plugging in tools

that have the switch on invites accidents.

• Remove adjusting keys or wrenches before turning the tool on. A wrench

or a key that is left attached to a rotating part of the tool may result in

personal injury.

• Do not overreach. Keep proper footing and balance at all times. Proper

footing and balance enable better control of the tool in unexpected

situations.

• Use safety equipment. Always wear eye protection. Dust mask, non-skid

safety shoes, hard hat, or hearing protection must be used for appropriate

conditions.

• Before connecting the tool to a power source (receptacle, outlet, etc.),

be sure that the voltage supplied is the same as that speciﬁed on the

nameplate of the tool. A power source with voltage greater than that

speciﬁed for the tool can result in serious injury to the user – as well as

damage to the tool.