Owner`s manual

6
SPECIFIC SAFETY RULES FOR THE HAMMER DRILL
• Hold the tool by its insulated gripping surfaces when performing any
operation where the tool may come into contact with hidden wiring or
its own cord. Contact with a “live” wire will make exposed metal parts of
the tool “live” and shock the operator.
• Only use accessories that are in good condition.
• Check that there is sufficient clearance for the drill bit under the
workpiece before drilling,
• Before plugging the tool in, check that the trigger lock-on button is “OFF”.
• When starting the hammer drill, let the drill run for a few seconds before
using it on a workpiece. Watch for vibration or wobbling that could
indicate poor installation of an accessory.
• Always use the auxiliary handle that is included with the tool. Loss of
control can cause personal injury.
• If possible, always use clamps or a vise to hold the work.
• Always switch the drill OFF before putting it down.
• Ensure that the lighting is adequate to see the operation.
• Do not put pressure on the drill to the extent that it slows down the motor.
For better results, and to lengthen the life of the drill, allow the drill bit to
cut without pressure.
• Keep the work area free of tripping hazards.
• Secure the material that is being drilled. Never hold it in your hand or
across your hand or across your legs.
• Do not use damaged or bowed drill bits.
• Keep hands away from rotating parts.
• Always wear safety goggles and a dust mask when drilling, especially
when drilling above the level of your head.
• Watch out for flying sparks. Hold the tool so that any sparks will fly away
from the operator and other persons. Keep all flammable materials away
when using this drill.
• Do not touch the workpiece immediately after operation. It may be
extremely hot, and could burn the skin.
• If an extension cord is required, use a cord with adequate size
conductors in order to prevent excessive voltage drop, loss of power, or
overheating. The table on the next page shows the correct size to use,
depending on cord length and nameplate amperage rating of tool. When
in doubt, use the next heavier gauge. Always use UL and CSA listed
extension cords.