Owner`s manual

1. To open the chuck jaws, insert the chuck key into one of the three holes

located on the chuck. Turn the key counter-clockwise.

2. Insert the bit into the chuck jaws. Center the bit in the chuck jaws.

3. To close the chuck jaws, insert the chuck key into one of the three holes

in the chuck. Turn the chuck key clockwise until the chuck is tightened

securely.

To remove:

1. Insert the chuck key into one of the holes in the chuck.

2. Turn the chuck key counter-clockwise to loosen the chuck.

3. Remove the bit.

WARNING! The bit can become very hot during use. Wear gloves or wait

for the bit to cool before removing the bit.

INSTALLING THE AUXILIARY

HANDLE (Fig. 4)

Loosen the auxiliary handle by

turning it counter-clockwise. Rotate

the handle to any position, and then

tighten the handle.

INSTALLING THE DEPTH

GAUGE (Fig. 5)

Loosen the knob, adjust the depth

gauge to the desired position, and

then tighten the knob.

Fig. 5

Knob

Fig. 4