Owner`s manual

Completely remove the spindle-clamping screw “A,” the outer “D”

washer, and the blade (see Fig. 21).

The remaining washer is the inner bushing washer that ﬁts around the

spindle shaft; it does not need to be removed.

10. Put a drop of oil onto the inner bushing washer and outer “D” washer

where they will touch the blade.

11. Place the new saw blade inside the lower blade guard, onto the spindle

shaft, and against the inner bushing.

NOTE: The teeth of the blade should point upward at the front of the saw. The

printed side will face outward when using the blade included with the saw.

12. Replace the “D” washer.

13. Firmly hold down the spindle lock button as you replace the spindle screw

and hand tighten it in a counterclockwise direction. Then use the blade

wrench to securely tighten the spindle clamping screw.

LUBRICATION

All of the bearings in this tool are lubricated with a sufﬁcient amount of high-

grade lubricant for the life of the tool under normal operating conditions.

Therefore, no further lubrication is required.