Owner`s manual

8
ASSEMBLY AND ADJUSTMENT
ATTACHING A SANDING SHEET
Remove the plug from the power source.
Select the required grade of sanding sheet.
To attach an ordinary (non Hook &
Loop type) sanding sheets, lift the
clamping levers (10) up and out of
the base to release the clamps (9)
at both ends of the sanding base (6).
(Fig. 2)
Align the holes in the sanding sheet
with those in the base (6), insert one
end of the sanding sheet under the
clamp (9) and close the clamping
lever (10), draw the sanding sheet
tight over the sanding base and then clamp the other end.
If the sheets do not have holes, attach as described above and use the hole
punch as described below.
The sheet should be kept tightly clamped over the base (6); otherwise there
could be excessive wear of the base materials.
WARNING! Do not continue to use the sander with a sanding sheet that is
excessively worn or damaged.
WARNING! Do not use the same sanding sheet for wood and metal. Metal
particles become embedded in the sanding sheet and will scour a wooden
surface.
WARNING! Take care to regularly clean out the dust build up on the base
underneath the sanding sheet and do not to allow the sanding sheet wear
completely down before replacing it. Failure to observe these two precaution-
ary measures can lead to damage to the hooks and loops on the base and the
sanding sheet will not attach properly.
Fig. 2