Use And Care Manual

Page 10
ASSEMBLY
REMOVING BITS (FIG. 2)
1. Lock the variable-speed trigger switch
by placing the direction-of rotation
selector in the center position.
2. Rotate the chuck sleeve
counterclockwise (viewing from chuck
end).
WARNING:
Use protective gloves
when removing the bit from the tool, or
rst allow the bit to cool down. The bit
may be hot after prolonged use.
INSTALLING AND REMOVING
THE BELT CLIP (FIG. 3)
To install the belt clip:
1. Align the rib of the clip with the groove
of the drill/driver, and then attach the
belt clip to the drill/driver.
2. Insert the screw (included) and tighten
the screw securely with a screwdriver
(not included). The belt clip can be
positioned on either side of the tool.
To remove the belt clip:
1. Use a screwdriver (not included) to
loosen the screw that attaches the belt
clip to the drill/driver.
2. Remove the screw and the belt clip.
FIG. 3
Screw
Attach
MAGNETIC BIT STORAGE
(FIG. 4)
The bit can be kept on the magnetic bit
storage area on the tool.
FIG. 4
Magnetic bit storage