Use And Care Manual

Page 10
ASSEMBLY
REMOVING BITS (FIG. 3)
1. Lock the trigger switch on the impact
driver by placing the direction-of-
rotation selector in the center position.
2. Pull the sleeve towards the front of
the tool.
3. The bit should pop out from the chuck
automatically, if not, simply remove
the bit.
WARNING:
Use protective gloves
when removing the bit from the tool, or
rst allow the bit to cool down. The bit
may be hot after prolonged use.
FIG. 3
Sleeve
INSTALLING AND REMOVING
THE BELT CLIP (FIG. 4)
To install the belt clip:
1. Align the rib of the clip with the groove
of the impact driver, and then attach the
belt clip to the impact driver.
2. Insert the screw (included) and tighten
the screw securely with a screwdriver
(not included). The belt clip can be
positioned on either side of the tool.
To remove the belt clip:
1. Use a screwdriver (not included) to
loosen the screw that attaches the belt
clip to the impact driver.
2. Remove the screw and the belt clip.
FIG. 4
Screw
Attach
MAGNETIC BITS STORAGE
(FIG. 5)
The bit can be kept on the magnetic bit
storage area on the tool.
FIG. 5
Magnetic bit storage