Product Manual

Page 10
DIRECTION-OF-ROTATION
SELECTOR (FORWARD/CENTER
LOCK/REVERSE) (FIG. 2B)
FIG. 2B
FORWARD
REVERSE
The direction of rotation is reversible and is
controlled by a selector located above the
trigger switch. With the drill held in normal
operating position, the direction of rotation
selector should be positioned to the left of
the trigger switch for drilling. The drilling
direction is reversed when the selector is
to the right of the trigger switch. When the
selector is in center position, the trigger
switch is locked.
To stop, release trigger switch and allow the
chuck to come to a complete stop.
NOTICE: To prevent gear damage, always
allow the right angle drill to come to
a complete stop before changing the
direction of rotation.
NOTICE: The right angle drill will not run
unless the direction of rotation selector is
engaged fully to the left or right.
ELECTRIC BRAKE
To stop the right angle drill, release the
trigger switch and allow the tool to come to a
complete stop. The electric brake quickly
stops the chuck rotation. This feature engages
automatically when you release the trigger
switch.
WARNING:
when placing battery
pack on the tool, be sure that the raised
rib on battery pack aligns with the groove
on the saw and the latches snap into
place properly. Improper assembly of
the battery pack can cause damage to
internal components.
TRIGGER SWITCH (FIG. 2A)
FIG. 2A
Variable-
speed
Trigger
Switch
Direction
of Rotation
Selector
(Forward/
Center Lock/
Reverse)
To turn the drill ON, depress the trigger
switch. To turn it OFF, release the trigger
switch.
VARIABLE SPEED (FIG. 2A)
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
OPERATION