Product Manual

Page 12
3. Insert the drill bit straight into the chuck
the full length of the jaws.
4. To tighten: grasp and hold the tool with
one hand, while rotating the chuck with
your other hand.
NOTICE: Rotate the chuck in the direction
of the arrow marked LOCK to tighten the
chuck jaws. Do not use a wrench to tighten
or loosen the chuck jaws.
REMOVING BITS (FIG.5)
1. Lock the trigger switch by placing the
direction of rotation selector in center
position.
2. To loosen the chuck jaw: grasp and hold
the tool with one hand, while rotating
the chuck with your other hand.
NOTICE: Rotating the chuck in the direction
of the arrow marked UNLOCK to loosen
the chuck jaws. Do not use a wrench to
tighten or loosen the chuck jaws.
3. Remove the drill bit from the chuck
jaws.
WARNING:
The bit may be hot after
use. Wear protective gloves or wait until the
bit has cooled down before removing the
bit.
WARNING:
Make sure to insert the
drill bit straight into the chuck jaws. Do not
insert the drill bit into the chuck jaws at an
angle, and then tighten. This could cause
the drill bit to be ejected from the drill,
resulting in possibly serious personal injury
or damage to the chuck.
BIT STORAGE (FIG. 6)
FIG. 6
When not in use, bits provided with the drill
can be placed in the storage area located on
the base of the drill.
DRILLING (FIG. 7)
FIG. 7
When drilling hard, smooth surfaces, use
a center punch to mark the desired hole
location. This will prevent the drill bit from
slipping off center as the hole is started.
The material to be drilled should be
secured in a vise or with clamps to keep it
from turning as the drill bit rotates. Hold the
tool firmly and place the bit at the point to
be drilled. Depress the trigger switch to start
the tool.
OPERATION