Product Manual

Page 11
INSTALLING MOTOR IN PLUNGE
BASE (FIG. 5)
FIG. 5
Arrow
Lock
lever
Motor
clamp
1. Disconnect the plug from the power
supply.
2. Place the plunge base on a flat surface.
3. With the back of the plunge base facing
you, open the motor clamp and make
sure that the plunge action is in the
“DOWN” position, with the plunge-lock
lever locked.
4. With the arrows aligned, lower the motor
housing into the plunge base.
5. Slide the motor into the base as far as it
will go.
6. Close the motor clamp securely.
REMOVING MOTOR FROM THE
FIXED BASE (FIG. 4)
1. Disconnect the plug from the power
supply.
2. Place the router on a flat surface.
3. With the back of the router facing you,
open the router motor clamp.
4. Push in the coarse-adjustment button
while you lift the router motor out of the
fixed base.
5. Set the motor upside down on its top
cap with the collet pointing up and
remove the cutter bit.
REMOVING MOTOR FROM THE
PLUNGE BASE (FIG. 5)
1. Disconnect the plug from the power
supply.
2. Place the router on a flat surface.
3. With the back of the plunge base facing
you, open the motor clamp and make
sure that the plunge action is in the
“DOWN” position with the plunge-lock
lever locked.
4. Lift the motor straight up out of the
base.
5. Set the motor upside down on its top
cap with the collet pointing up and
remove the cutter bit.
ASSEMBLY