26" Tool Cart Actual product may differ slightly from image shown. Model #: 245-1682 OPERATOR’S MANUAL CAUTION: To reduce the risk of injury, user must read and understand operator’s manual. Save these instructions for future reference.
TABLE OF CONTENTS Safety Symbols.......................................................................... 2 Safety Instructions...................................................................... 3 Parts List.................................................................................... 4 Assembly and Operation............................................................ 5 Maintenance and Safety.............................................................
SAFETY SYMBOLS Model #:________________________________ CAUTION: 1. Read and follow all safety and assembly instructions before using this product for the first time. 2. Fill in the following information and retain the manual for future reference: Place of purchase:_______________________ Date of purchase:________________________ Receipt # of purchase:___________________ Do not open more than one drawer at a time. Do not step on drawers or trays. Do not allow children near the unit.
SAFETY INSTRUCTIONS The purpose of safety symbols is to attract our attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The symbol warnings do not by themselves eliminate any danger. The instructions and warnings they give are no substitute for proper accident prevention measures.
PARTS LIST For service regarding parts, assembly or warranty information, please call 1-800-459-4409. The keys are taped to the top of the caster carton, which is placed in the bottom tray of the cart.
ASSEMBLY AND OPERATION NECESSARY TOOLS REQUIRED FOR ASSEMBLY INSTALL BOTTOM TRAY • 10 mm socket (for side handle) Carefully turn the cart upside down and lay its top on to a protective surface. Position the bottom tray over the bottoms of the pillars. Attach the bottom tray to each pillar with four (4) M6x12 Phillips screws. Tighten securely. • 14 mm socket • Extension ratchet • Phillips screwdriver INSTALL PILLARS Position the pillars over the holes in the upper part of the cart.
ASSEMBLY AND OPERATION INSTALL SIDE HANDLE TO REMOVE DRAWERS Position the side handle over the holes in the upper part of the tool cart and attach with four (4) M6x12 hex bolts. Tighten securely. Pull the drawer out so it is almost fully extended. PUSH UP on the black release lever on one side, while PULLING DOWN on the black release lever on the other side. While holding the levers in the positions as instructed above, pull the drawer outward until it is released from the drawer slide.
MAINTENANCE AND SAFETY MAINTENANCE For casters, use high quality bearing grease (annually/yearly). Lubricate the slides (twice a year) with a product like WD40 or other quality lubricant. This is especially important when the temperature decreases, as the bearing can become stiff. Periodically the drawer fronts, drawer trim, and other surfaces should be cleaned with mild detergent and water. Auto wax will preserve the storage unit’s luster finish. Apply the wax as you would to a car.
NOTES Page 8
NOTES Page 9
26" Tool Cart LIMITED LIFETIME WARRANTY MASTERFORCE® Tool Cabinets and Chests have been manufactured to the highest standards of quality and workmanship and are warranted to be free from defects in materials and workmanship under normal use for the lifetime that you own the product. If any part of the product is found to be defective during normal use, the defective product or part will be replaced at our discretion.
©2018 Menard, Inc.
