Use And Care Manual

Page 6
ASSEMBLY AND OPERATION
INSTALL SIDE HANDLE
Position the side handle over the holes
in the upper part of the tool cart and at-
tach with four (4) M6x12 hex bolts. Tighten
securely.
RAISE AND RELEASE
DRAWER FRONTS
These units are equipped with the raise
and release drawer front system.
To open, lift up on the drawer front while
pulling out towards you.
To close, shut the drawer firmly until the
latch engages.
If the drawer does not stay closed, the
drawer contents may be the obstruction,
or the hook may be slightly bent or it may
be rubbing up against the drawer slides. To
resolve this problem, lightly bend the hook
until the drawer engages in the slide.
TO REMOVE DRAWERS
Pull the drawer out so it is almost fully
extended. PUSH UP on the black release
lever on one side, while PULLING DOWN
on the black release lever on the other side.
While holding the levers in the positions as
instructed above, pull the drawer outward
until it is released from the drawer slide.
PUSH UP (ONE SIDE)
PULL DOWN (OTHER SIDE)
TO REPLACE DRAWERS
Extend the drawer slides from the tool cart.
Insert the brackets on each side of the
drawer into the slots in the tool cart slides,
being careful that they are positioned
properly. Once properly inserted,
completely close the drawer to set the
slides in their proper positions.