Use And Care Manual

ManualsBrandsMasterforce ManualsTool Chests30" x 24" Gunmetal 16-Drawer Tool Chest & Cabinet Combo with Side Box

Page 2

30" Tool Chest & Cabinet

Chest Model #: 245-190 0/245 -1904/245-1908/245 -1912

Cabinet Model #: 245-1902/245-1906/245-1910/245-1914

CAUTION:

To Reduce The Risk Of Injury, User Must Read

And Understand Operator’s Manual. Save These Instructions

For Future Reference.

OPERATOR’S MANUAL

Actual product may differ

slightly from image shown

EACH UNIT SOLD SEPERATELY

Summary of content (6 pages)

PAGE 1
30" Tool Chest & Cabinet Actual product may differ slightly from image shown EACH UNIT SOLD SEPERATELY Chest Model #: 245-1900/245-1904/245-1908/245-1912 Cabinet Model #: 245-1902/245-1906/245-1910/245-1914 OPERATOR’S MANUAL ©2017 Menard, Inc., Eau Claire, WI 54703 V1 07/2017 CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference.
PAGE 2
TABLE OF CONTENTS Safety Symbols.......................................................................... 2 Safety Instructions...................................................................... 3 Parts List.................................................................................... 4 Assembly and Operation............................................................ 5 Maintenance and Safety.............................................................
PAGE 3
SAFETY INSTRUCTIONS PARTS LIST The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The symbol warnings do not by themselves eliminate any danger. The instructions and warnings they give are no substitute for proper accident prevention measures. For service regarding parts, assembly or warranty information, please call: 1-800-459-4409.
PAGE 4
ASSEMBLY AND OPERATION NECESSARY TOOLS REQUIRED FOR ASSEMBLY INSTALL THE CASTERS • 10 mm socket NOTE: Two or more people may be required to complete this step. • 14 mm socket • Extension ratchet INSTALL THE HANDLE Position the handle over the holes and attach with the M6 x 12 hex bolts. Tighten securely using a 10 mm socket. Carefully lay the bottom cabinet on its back using a soft mat under the back for protection.
PAGE 5
MAINTENANCE AND SAFETY MAINTENANCE Lubricate the casters with high quality bearing grease once a year. Lubricate the slides twice a year with a product like WD40 or other quality lubricant. This is especially important when the temperature decreases, as the bearing can become stiff. Periodically clean the drawer fronts, drawer trim, and other surfaces with mild detergent and water. Auto wax will preserve the storage unit’s luster finish. Apply the wax as you would to a car.
PAGE 6
NOTES 30" Tool Chest & Cabinet LIMITED LIFETIME WARRANTY MASTERFORCE® Tool Cabinets and Chests have been manufactured to the highest standards of quality and workmanship and are warranted to be free from defects in materials and workmanship under normal use for the lifetime that you own the product. If any part of the product is found to be defective during normal use, the defective product or part will be replaced at our discretion.