72" Tool Cabinet Actual product may differ slightly from image shown EACH UNIT SOLD SEPERATELY Cabinet Model #: 245-1980/245-1982/245-1984/245-1986 OPERATOR’S MANUAL CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference.
TABLE OF CONTENTS Safety Symbols.......................................................................... 2 Safety Instructions...................................................................... 3 Parts List.................................................................................... 4 Assembly and Operation............................................................ 5 Maintenance and Safety.............................................................
SAFETY SYMBOLS Model #:_________________________________ CAUTION: 1. Read and follow all safety and assembly instructions before using this product for the first time. 2. Fill in the following information and retain the manual for future reference: Place of purchase:________________________ Date of purchase:________________________ Receipt # of purchase:____________________ Do not open more than one drawer at a time. Do not step on drawers. Do not allow children near the unit.
SAFETY INSTRUCTIONS The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The symbol warnings do not by themselves eliminate any danger. The instructions and warnings they give are no substitute for proper accident prevention measures.
PARTS LIST For service regarding parts, assembly or warranty information, please call: 1-800-459-4409. The keys are taped to the inside of the top right drawer of the cabinet.
ASSEMBLY AND OPERATION NECESSARY TOOLS REQUIRED FOR ASSEMBLY • 10 mm socket • 14 mm socket • Extension ratchet INSTALL THE HANDLE Position the handle over the holes and attach with the M6 x 12 hex bolts provided. Tighten securely using a 10 mm socket. INSTALL THE CORD WRAP Position the cord wrap over the holes and attach with the M6 x 12 Phillips head bolts. TIghten securely.
ASSEMBLY AND OPERATION RAISE AND RELEASE DRAWER FRONTS This unit is equipped with raise and release drawer fronts. To open, lift up on the drawer front while pulling towards you. To close, shut the drawer firmly until the latch engages. TO REMOVE DRAWERS Pull the drawer out so it is almost fully extended. PUSH UP on the black release lever on one side, while PULLING DOWN on the black release lever on the other side.
MAINTENANCE AND SAFETY MAINTENANCE Lubricate the casters with high quality bearing grease once a year. Lubricate the slides twice a year with a product like WD40 or other quality lubricant. This is especially important when the temperature decreases, as the bearing can become stiff. Periodically clean the drawer fronts, drawer trim, and other surfaces with mild detergent and water. Auto wax will preserve the storage unit’s luster finish. Apply the wax as you would to a car.
MAINTENANCE AND SAFETY WARNING: To prevent the chest from easily tipping over, fasten the screws to connect the chest and cabinet. POWER STRIP MODEL: LTS-04C SURGE PROTECTIVE DEVICES RATING: 120V AC 15A 60Hz 1875W USB: TOTAL 2.1 A USB O/P: IT EQUIPMENT ONLY • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
NOTES Page 9
72" Tool Chest & Cabinet LIMITED LIFETIME WARRANTY MASTERFORCE® Tool Cabinets and Chests have been manufactured to the highest standards of quality and workmanship and are warranted to be free from defects in materials and workmanship under normal use for the lifetime that you own the product. If any part of the product is found to be defective during normal use, the defective product or part will be replaced at our discretion.
©2017 Menard, Inc.