Use And Care Manual

Page 18
1. Inspect the corded circular saw, the
trigger switch and the accessories for
damage.
2. Check for damaged, missing, or worn
parts.
3. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
4. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
5. Unplug the tool from power source
before cleaning or performing any
maintenance. Using compressed air
may be the most effective cleaning
method. Always wear safety goggles
when cleaning tools using compressed
air.
WARNING:
• Always wear safety goggles or safety
glasses with side shields during power
tool operations, or when blowing dust. If
operation is dusty, also wear a dust mask.
• Do not at any time let brake fluids,
gasoline, petroleum-based products,
penetrating oils, etc. come in contact
with plastic parts. Chemicals can damage,
weaken or destroy plastic, which may result
in serious personal injury.
• When servicing, use only identical
replacement parts. The use of any other
parts may create a hazard or cause damage
to the product.
• Use only accessories that are
recommended for this circular saw by
the manufacturer. Accessories that may
be suitable for one tool may become
hazardous when used with another tool.
• Maintain tools with care. Keep cutting
tools sharp and clean. Properly maintained
tools with sharp cutting edges are less
likely to bind and are easier to control.
MAINTENANCE
• To ensure safety and reliability, all
repairs should be performed by a qualified
service technician.