Use And Care Manual

Page 10
OPERATION
DIRECTION-OF-ROTATION
SELECTOR (FIG. 3)
FIG. 3
Forward
Reverse
The direction of bit rotation is reversible and
is controlled by a selector located above the
trigger switch. With the impact driver held in
normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation.
2. Position the direction-of-rotation
selector to the left of the tool for forward
rotation.
3. Setting the direction-of-rotation selector
in the OFF (center-lock) position helps
reduce the possibility of accidental
starting when not in use.
NOTICE: To prevent gear damage,
always allow the impact driver to come
to a complete stop before changing the
direction of rotation.
ELECTRIC BRAKE
To stop the impact driver, release the trigger
switch and allow the chuck to come to a
complete stop. The electric brake quickly
stops the chuck from rotating. This feature
engages automatically when you release the
trigger switch.
LED WORKLIGHT (FIG.4)
FIG. 4
LED worklight
The LED worklight, located on the base of
the impact driver, will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the
workpiece. The LED worklight will turn off a
few seconds later after the trigger switch is
released.