Use And Care Manual

Page 12
OPERATION
INSTALLING BITS (FIG. 7)
FIG. 7
1. Lock the trigger switch by placing the
direction-of-rotation selector in the OFF
(center) position.
2. Insert the 1/4 in. bit into the bit retainer.
You will hear a “click” to indicate that
the bit is securely installed in place.
3. Pull the bit to check if it installed
securely.
NOTICE: If the bit diameter is larger than
1/4 in., use a suitable adapter (available
separately) to install the bit.
REMOVING BITS
1. Lock the trigger switch by placing the
direction-of rotation selector in the OFF
(center) position.
2. Pull the sleeve towards the front of the
tool.
3. Remove the bit
WARNING:
Use protective gloves
when removing the bit from the tool, or
rst allow the bit to cool down. The bit
may be hot after prolonged use.
TIGHTENING AND LOOSENING
SCREWS AND NUTS
1. Install the correct bit.
2. Apply just enough pressure to keep the
bit engaged on the screw or nut.
3. Apply minimal pressure to the trigger
switch initially. Increase the speed only
when full control can be maintained.