Use And Care Manual

Page 10
OPERATION
DIRECTION-OF-ROTATION
SELECTOR (FIG. 3)
FIG. 3
Forward
Reverse
The direction of bit rotation is reversible and
is controlled by a selector located above the
trigger switch. With the impact wrench held
in normal operating position:
1. Position the direction-of-rotation
selector to the right of the tool for
reverse rotation.
2. Position the direction-of-rotation
selector to the left of the tool for forward
rotation.
3. Setting the direction-of-rotation selector
in the OFF (center-lock) position helps
reduce the possibility of accidental
starting when not in use.
NOTICE: To prevent gear damage, always
allow the impact wrench to come to
a complete stop before changing the
direction of rotation.
ELECTRIC BRAKE
To stop the impact wrench, release the
trigger switch and allow the chuck to come
to a complete stop. The electric brake
quickly stops the chuck from rotating. This
feature engages automatically when you
release the trigger switch.
LED WORKLIGHT (FIG.4)
FIG. 4
LED worklight
The LED worklight, located on the base of
the impact wrench, will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the
workpiece. The LED worklight will turn off a
few seconds later after the trigger switch is
released.
INSTALLING AND REMOVING
THE BELT CLIP (FIG.5)
FIG. 5
Belt clip
Screw
To install the belt clip:
1. Align the rib of the clip with the hole on
the base of the impact wrench.
2. Insert the screw (included) and tighten
the screw securely with a screwdriver.
The belt clip can be positioned on either
side of the tool.