Use And Care Manual

Page 11
OPERATION
Correct Incorrect
3
1
1. Blade
2. Bearing
3. Upper holder
4. Lower holder
4
2
FIG. 7
The band saw is equipped with a LED
worklight, which will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the
workpiece for operation in lower-light areas.
The light will stay on for about 10 seconds
after the trigger switch has been released.
TYPICAL APPLICATION (FIG.8)
Correct Incorrect
FIG. 8
1. To turn the tool ON, push the lock-off
buttonand depress the trigger switch.
2. Keep the blade off the workpiece until the
motor has reached full speed.
3. Start cutting on a surface where the
greatest number of teeth will be in contact
with the workpiece at one time (Fig 8).
4. Place the work steady rest against the
workpiece and lower the moving saw
blade into the cut.
5. Do not bear down while cutting. The
weight of the tool will supply adequate
pressure for the fastest and safest
cutting.
6. When completing a cut, hold the tool firmly
so it will not fall against the work-piece.
7. Remove the saw from the cut before
releasing the trigger switch to turn the
saw off.
LED worklight