Installation Instructions

1. Remove the contents from the box and lay out on an even surface.
2. Remove the ratcheting handle, (3) selector switch, (10) ratcheting handle gear, (16) and
the ratcheting handle screw, (13) from the poly bag included in the vise box.
3. Center the selector switch, (10) with one hand and place the ratcheting handle gear, (16)
in between the tines of the ratcheting handle, (3).
4. While holding this assembly, (step 3 above) slide the ratcheting handle, (3) and the
ratcheting handle gear, (16) onto the end of the ACME screw, (11).
5. After the assembly is complete, screw in the Ratcheting Handle Screw (13) using a
5mm hex key.
6. Be careful not to overtighten the screw in the handle assembly.
15. Carefully check for damaged parts or any other conditions that may affect operation before
using this product. Repair or replace damaged and worn components immediately.
16. When servicing, use only identical, manufacturer-recommended replacement parts.
17. Maintain product with care. Keep this product clean and dry, and all moving parts lightly
lubricated for better performance. Keep the handle dry, clean and free from oil, grease,
and solvents.
18. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the
work of a larger industrial tool. This vise was designed for specific applications. Do not
modify this tool or use it for any purpose other than that for which it was intended.
Page 7
ASSEMBLING THE HANDLE
MOUNTING THE VISE
Page 2
1. Select a solid, level mounting surface capable of supporting the combined weight of the
vise, intended workpieces and applicable forces.
2. Unlatch the Swivel Base Casting (14) and remove the Posi-Clock Disc (8).
3. Place the Posi-Clock Disc (8) onto your intended mounting surface.
4. Locate the “0” on your Posi-Clock Disc (8) and mount onto your bench in the
desired orientation.
5. Use the holes in the Posi-Clock Disc (8) as a template to mark the bench surface. With a
pencil trace the inside of the machined holes.
6. Remove the Posi-Clock Disc (8) and drill holes for mounting hardware (not included).
Be sure to pre-fit the bolts into the swivel Posi-Clock Disc (8) to insure the head of the
bolt fits into the counter bore. The head of the bolt cannot rest above the surface of the
plate, as it will not allow the vise to be mounted to the Posi-Clock Disc (8).
NOTES