Installation Instructions

1. To adjust the opening of the vise clamping pads, loosen the T-style Swivel Base Locks (5)
located on either side of the adjustable Swivel Base Casting (14). Grasp the Ratcheting
Handle (3) firmly with one hand and the Swivel Base Casting (14) with the other to rotate the
entire vise to your desired position. Once the orientation of the vise has been finalized,
screw down both of the T-style Swivel Base Locks (5) until they’re engaged into the
“V-shaped” channels located along the outer edge of the Posi-Clock Disc (8). SEE FIGURE 1.
The vise should be firmly fixed into the desired position. If the vise still moves, slightly rotate
the vise in either direction until the vise locks into place.
2. To quickly adjust the opening of the vise, depress the Speed Jaw™ Release Button (4) with
one hand while pulling on the Ratcheting Handle (3) with the other hand. The handle should
be in the up position. This will rapidly open and or close the jaws to the desired width.
3. To tighten the Serrated Jaws (7), depress the Selector Switch (10) to the left and begin
moving the Ratcheting Handle, (3) in a clockwise direction until a satisfactory grip is
achieved. DO NOT OVERTIGHTEN. At no point should you use an extended pipe, tube or
hammer to decrease the amount of force applied to the adjustable Ratcheting Handle, (3)
as it will damage the vise.
4. To loosen the Serrated Jaws (7), depress the Selector Switch (10) to the right and begin
moving the Ratcheting Handle, (3) in a counter-clockwise direction. At no point should you
use an extended pipe, tube or hammer to decrease the amount of force applied to the
adjustable Ratcheting Handle, (3) as it will damage the vise.
5. Should the user decide to remove the Swivel Base Casting (14) and mount directly to a
bench top, the Cast Body Attachment Screws (9) can be removed (4pcs). At this point, the
vise can be attached to the bench using the set of holes for the Cast Body Attachment
Screws (9) in either in Portion A or Portion B of the vise. SEE FIGURE 4.
7. Align bolt mounting holes with drilled holes then attach the Posi-Clock Disc (8) to your
surface using attaching screws (not included) being sure not to overtighten. All five
mounting points should have mounting hardware applied.
8. Unlatch the Swivel Base Lock (5) to the point where it will not interfere with the Posi-Clock
Disc (8) when installing the vise.
9. Slide the Swivel Base Casting (14) portion of the vise over the Posi-Clock Disc (8) and latch
the base closed using the Swivel Base Latch (6).
Page 3
OPERATION
Page 6
1. Avoid using solvents when cleaning.
2. Most items are susceptible to damage from various types of commercial solvents.
3. Use clean cloths to remove dirt, dust, oil, grease, etc.
4. Lubricate regularly.
MAINTENANCE