Installation Instructions

ManualsBrandsMasterforce ManualsPower Tool AccessoriesAdjustable Clamping Work Table

[M/flSTEAF,iJRl:£4®

Adjustable Clamping Work Table

240-1579

OPERATOR’S MANUAL

CAUTION:

To Reduce The Risk Of Injury, User Must Read And

Understand Operator’s Manual. Save These Instructions For Future Reference.

Summary of content (4 pages)

PAGE 1
Adjustable Clamping Work Table ® 4 £ : l R J ,i F A E T S l [M/f 240-1579 OPERATOR’S MANUAL [ACAUTION:JTo Reduce The Risk Of Injury, User Must Read And © 2016 Menard, Inc., Eau Claire, WI 54703 Understand Operator’s Manual. Save These Instructions For Future Reference.
PAGE 2
TABLE OF CONTENTS Save this Manual.............................................................................. Safety ............................................................................................... Parts List........................................................................................... Assembly Instructions...................................................................... Functions..........................................................................................
PAGE 3
FUNCTIONS SAFETY Height Adjustment (seven levels). a. Turn the height adjustment knobs counter-clockwise on each leg to loosen (fig. 1). b. Push the elevating swing bar back with your foot to disengage the two hooks and adjust the height of the bench upwards (fig. 2) or downwards (fig. 3). c. Use the elevating swing bar to ensure the two hooks are re-engaged into the two elevating rods’ adjustment holes. 15. Make sure your work platform is sufficiently sturdy to do the specific job at hand 16.
PAGE 4
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 07 5 0-----:~~ 01 3 2 o--- -t11 010 "i!H"' -----t----012 6 4 4 x2 11 '---l-,l-=,,-\------r-----0 3 8 1. Attach four leg feet (8) to the leg frame (4). 2. Attach cross bar (3) to the two elevating rods (2) with M6 x 35 hex bolts (9), M6 Nylon nuts (11) and M6 washers (12). Make sure the seven pre-drilled holes on both elevating rods are on the opposite side and the adjusting knobs are on the outside of the assembly. 3.